TFH70F.doc vers ion 1.2 20.06.2001 vi telefilter filter specification tfh 70f 1/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784- 30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make ch anges to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights unde r any patent accompany the sale of any such product(s) or infor mation. measurement condition ambient temperature: 25 c input power level: 10 dbm terminating impedances * ) : for input: 330 ? ?? -13,7 pf for output: 250 ? ?? -15,7 pf remark: reference level for the relative attenuation a rel of the tfh 70f is the insert ion loss. the insertion loss a e is defined as the in sertion loss at the nominal frequency f n . the centre frequency f c is the arithmetic mean value of the upper and lower frequencies at the 3 db filter attenuation level relative to the insertion loss a e . the given values for the inserti on loss, the relative attenuation a rel and the group delay ripple have to be reached at the frequencies given below al so if the centre frequency f c is shifted due to the temper ature coefficient of frequency tc f in the operating temperature range and due to a production tolerance for the centre frequency f c . d a t a typ. value tolerance/limit insertion loss a e 20,6 db max. 24,0 db (reference level) nominal frequency f n - 70,0 mhz passband pb f n 0,40 mhz passband variation p-p 0,25 db 0,65 db 3 db bandwidth bw 1,338 mhz min. 1,156 mhz 40 db bandwidth bw 1,988 mhz max. 2,180 mhz relative attenuation a rel f n 0,578 mhz ....... max. 3 db f n - 1,09 mhz ....... f n - 1,50 mhz 43 db min. 40 db f n + 1,09 mhz ....... f n + 1,50 mhz 45 db min. 40 db f n 1,50 mhz ....... f n 4,00 mhz 48 db min. 45 db f n 4,00 mhz ....... f n 20 mhz 54 db min. 50 db phase linearity in f n 0,578 mhz 3,3 max. 5,5 group delay variation in f n 0,578 mhz 105 ns max. 175 ns absolute group delay 3,1 s max. 4,0 s temperature coefficient of frequency tc f **) - 0,036 ppm/k2 operating temperature range - 20..+ 80 c storage temperature range - 25..+ 85 c * ) the terminating impedances depend on parasitics and q-values of matching elem ents and the board used, and are to be understood as reference values only. should there be additional questions do not hesitate to ask for an applicat ion note or contact our desig n team. **) ? f c (hz) = tc f (ppm/k 2 ) x (t - t a ) 2 x f cat (mhz) generated: checked / approved:
TFH70F.doc vers ion 1.2 20.06.2001 vi telefilter filter specification tfh 70f 2/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784- 30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make ch anges to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights unde r any patent accompany the sale of any such product(s) or infor mation. construction, pin configuration and 50 ? - matching network (all dimensions in mm) 50 ohm test circuit 5 10 1,2.3.4, 6,7,8, 9 , 11 in out tfh 70f l1 l2 datecode: year+week l 1999 m 2000 n 2001 .... 24.64 1 10 9 23 5 4 876 9.00 1.02 2.62 max 1.02 2.31 11 4.83 x 3.53 1.91 tfh 70f n25 pin configuration input: 10 input return: 1 output: 5 output return: 6 ground: 2,3, 4,7,8,9,11
TFH70F.doc vers ion 1.2 20.06.2001 vi telefilter filter specification tfh 70f 3/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784- 30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make ch anges to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights unde r any patent accompany the sale of any such product(s) or infor mation. stability characteristics after the following tests the filter shall meet the whole specification: 1. shock: 500g, 18 ms, half sine wave, 3 shocks each plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5g respective ly, 1 octave per min, 10 cycles per plan, 3 plans; din iec 68 t2 - 6 3. damp heat: 25 c to 55c / 95% r.h. / 10 cycles (cycle) din iec 68 - 2 ? 30 db 4. resistance to solder heat (reflow): max. 2 times reflow process; for temperature conditions refer to the attac hed "air reflow temperature conditions" on page 4; packing tape & reel: iec 286 - 3, with exception of value for n and minimum bending radius; tape type ii , embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 1000 reel of empty components at start: min 300 mm reel of empty components at start including leader: min 500 mm trailer min 300 mm the minimum bending radius is 45 mm. the m ounting surface of the filters faces the bottom side of the embossed carrier tape. the marking of the filters is able to read if the view is di rected on the upper side of the carrier tape with the sprocket hole s on the right side of the tape. reel (all dimensions in mm): a : 330 w1 : 46 w2 (max) : 50 n (min) : 100 c : 13 0,2 tape (all dimensions in mm) w : 44 0,3 po : 4 0,1 do : 1,5 + 0,1 e : 1,75 0,1 f : 20,25 0,05 g (min) : 0,75 p2 : 2 0,05 p1 : 16 0,1 d1(min) : 2,0 ao : 9,3 0,1 bo : 24,9 0,1 ct : 38 0,2 e embossed carrier tape cover tape g d 1 ct p 1 b o a o p 2 p 0 w f d 0 n w 2 w 1 a c
TFH70F.doc vers ion 1.2 20.06.2001 vi telefilter filter specification tfh 70f 4/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784- 30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make ch anges to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights unde r any patent accompany the sale of any such product(s) or infor mation. air reflow temperature conditions 1st and 2nd air reflow profile name: pre-heating periods main-heat ing periods peak temperature temperature: 150 c - 170 c over 200 c 255 c 5 c time: 60 sec. - 90 sec. 20 sec. - 25 sec. chip-mount air reflow profile time / sec. temperature / c 0 20 40 60 80 100 120 140 160 180 200 220 240 260 0 20 40 60 80 100 120 140 160 180 200 220 240 table for temperature vs. time during the air reflow process tolerance of temperatures: 5 c time / sec. temperature / c time / sec. temperature / c 0 23 140 160 10 34 150 161 20 46 160 164 30 60 170 170 40 80 180 180 50 103 190 205 60 121 195 230 70 134 200 255 80 143 205 230 90 150 210 205 100 154 215 180 110 156 220 165 120 158 230 140 130 159 240 120
TFH70F.doc vers ion 1.2 20.06.2001 vi telefilter filter specification tfh 70f 5/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784- 30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make ch anges to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights unde r any patent accompany the sale of any such product(s) or infor mation. history version reason of changes name date 1.0 generate specification pfeiffer 22.03.2001 1.1 change typical values pfeiffer 10.05.2001 1.2 terminated impedances added pfeiffer 20.06.2001 operating temperature range changed
|
